UV FAIL ALARM
Slim and sleek compact water purifier
KENT Prime KENT’s Mineral ROTM Water Purifier has an in-built feature that sounds an audible alarm if the UV lamp malfunctions. This feature is provided to ensure 100% purity. This UV Fail Alarm will sound like following: Two short beeps after every two seconds.
In case such an alarm is audible, kindly switch off the purifier and call the service technician for help. The purifier will stop its purification process in such a circumstance.
FILTER CHANGE ALARM
KENT Prime KENT’s Mineral RO has an in-built feature that sounds an audible alarm to indicate replacement time for filters. This alarm will be audible after 700 hrs of use since the last filter change (or since the time of installation). The Filter Change Alarm will sound like following:
4 short beeps after every two seconds; for 30 seconds. The alarm will repeat after every 2 hours of use.
In case such an alarm is audible, please call the service technician and request him to change the filters of the purifier. However, if the filters are not changed within the next 60 hours of operation, the purifier will stop functioning to ensure purity and hygiene. The following alarm will be audible after 60 Hrs. A continuous beep for an infinite time.
In case, such an alarm is audible, kindly switch off the purifier and call the service technician to replace the filters. In such a circumstance, the purifier will not function unless the filters are changed.
COMPUTER CONTROLLED OPERATION
To ensure delivery of 100% pure and healthy water, a micro-processor is installed in the purifier that performs the following functions: – UV Stabilization Delay: To ensure that the UV lamp is pre-heated and is working at its optimum level before it starts disinfecting water, the controller provides a two seconds delay to UV lamp when the purifier is switched on. During this period, only the UV lamp is switched on and other electrical devices of the purifier are switched off.
Purification Delay: To ensure that the idle water lying in the internal pipes and in the UV chamber is disinfected before being passed into the storage tank, the system provides 5 second delay when the purifier is switched on. During this time, the UV lamp kills all micro-organisms that may be in the water inside UV chamber. After this delay, all other electrical devices such as booster pump and solenoid valve are switched on to start normal purification process. Audible Alarm: The controller also controls the timing of UV Fail Alarm and the Filter Change Alarm.
The purifier automatically shuts off when the storage tank becomes full.
The purifier does not start when inlet water supply pressure is below 0.3 kg/cm2.
The purifier automatically restarts when water level drops below the maximum.
The purifier does not allow any water rejection in absence of electricity / when tank is full.
Suitable for Purification of Brackish / Tap Water
Upto 15 LPH*
On the Wall
L 410 W 260 H 520
INLET WATER PRESSURE/TEMP (MIN)
0.3Kg / cm2 or 4.267psi / 10°C
INLET WATER PRESSURE/TEMP (MAX)
3Kg / cm2 or 42.67psi / 35°C
Sediment, Carbon Block Filter, UF and Post Carbon
UV LAMP WATTAGE
PURIFICATION PRODUCTION RATE
MAXIMUM DUTY CYCLE
Thin Film Composite RO
BOOSTER PUMP VOLTAGE
24 V DC
INPUT POWER SUPPLY
100-300 V ~, 50 Hz, 800 mA
* Treatment capacity tested for tap water having TDS level of 750 ppm at room temperature